What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 04:31
Edit 2024–10.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
so, what happens?
Here is a simplified AC power diagram.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Video: Street Fighter 6 Showcases Four New Character Outfits - Nintendo Life
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
These are simplified answers to the original question, and does not change anything I wrote above.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Why do I sometimes hear full conversations when I am alone?
I post the exact comment here.
At one ohm, the resistor has a maximum of 1 watt power.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
[old diagram got deleted by accident]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
the problem then depends on "how fast does the fuse operate?".
Powerful solar telescope unveils ultra-fine magnetic 'curtains' on the sun's surface - Space
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but I think this circuit , shows a few more pieces.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
An AC voltage/ current source, and an ac inductive load.
what exactly is a ‘surge’ protector?
This is 'the assistant's answer'
Should Pete Rose's record as the all-time hits leader be recognized and celebrated?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
How does growing up in chaos affect a child as they become an adult?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
For this case there are devices called Metal oxide varistors (MOV).
This device then solves the entire problem.
Are there any men who have sex with male dogs?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The MOV will conduct when the voltage exceeds 50% of line voltage.
A circuit breaker is similar, but is resettable.
Citadel's Esposito says US deficit is a 'ticking time bomb' - Yahoo Finance
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
But… the neutral is now “floating” because of the 1 ohm resistance.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The European Central Bank is almost guaranteed to cut rates. Here's what could happen next - CNBC
eight
But it can get overloaded, and no longer works.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Barnstars:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Do you feel uncomfortable when you come across cross dressers?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
(Dc diagram shown, AC is similar).
The third is lightning and “how it gets conducted into a home.”
First Sentence:
The other is “what does a “fuse” do?”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Evidence piles up that Trump's tariffs are crushing job market - Daily Kos
A fuse is a non-resetable over current circuit protector.
2024–10–16 [ OO OLAOYE OYEBODE ]
The bolt then partially travels down the line to your home.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What does a fuse do?
These devices are installed between the “hot” and “neutral” and protective ground.
It seems Mohan does not understand the difference between a comment and an Answer.
a photo is worth a thousand words.
nine
He then asserts :
In schematic diagrams this is the symbol for a fuse:
This one hit behind the barn.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
There are three different concepts here that are getting confused.
At least they know the answer if they wanted it.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Upvotes:
but this device (an Inductor) … impedes the rapid changes in the current.
What is lightning?
One
2024–10–10[John johnson John Johnson ]
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–14 [Omar Gharbi Omar Gharbi ]
He then describes Rainy Season and Lightning.
Because the load is inductive, the current lags the voltage.(by a bit).
So, the voltage could go up to 500 volts, and the fuse will not open up.
Now when you have a certain ac resistance, then a current flows in a loop.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One is “what exactly is in a ‘surge protector’ ? ”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It also is a device that limits the change in current flow.
There are two important concepts here.